Saturday, June 2, 2018

ENOVEN E-SERIES Dump Bodies

 

ENOVEN E-SERIES

BODY: 10’ Long, 5.7 to 7.5 cubic yard capacity; 26” tall sides with 32” tall tailgate, 100% continuous welded

FRONT END: 32” tall 3/16” hi-tensile steel with 1” horizontal “V” brace, 20” cab protector, and 7ga hi-tensile steel full depth front corner pillars

SIDES: 26” tall 10 gauge hi- tensile steel outer panel with 3/16” hi-tensile steel inner panel. 6” sloping boxed top rail, 6” deep sloping bottom rail, 2” cheater board pockets, (1) horizontal “V” brace

TAILGATE: 32” tall 10 gauge hi-tensile steel outer panel with 3/16” hi-tensile steel inner panel. Dirt shedding top with standard 2-way operation, (1) horizontal “V” brace, 3/8” drop and spreader chains, 11” X 19” patch gate, and 8” bolt-on spreader apron

TAILGATE HARDWARE: Over center locking hardware with manual handle at left front of body

FLOOR: ¼” one piece hi-tensile steel with radius from side to floor

UNDERSTRUCTURE: 8” tall structural channel long sills, crossmemberless design

LIGHT SYSTEM: 6” Oval LED recessed grommet mounted S/T/T lamp in rear posts with 3/4” LED rear clearance and 2.5” LED rear side marker lamps. Three lamp ID bar above hitch plate

PAINT: Sandblasted, prepped, and cleaned. Primer painted with high impact resistant urethane light gray primer with a top coat of single stage urethane paint

HOIST: Champion under body, sub-frame mounted hoist. NTEA Class 60 rated at 22.1 tons with 50degree dump angle. Single body prop

No comments:

Post a Comment